Electronic Development Labs, Inc.
EDL Corporate Site
Home
Current Sales Special
Nervo-Scope®
ETS-6
Nervo-Scope®
ETS-7
Nervo-Scope®
ETS-8
Analagraph®
BTI temperature indicator
New Analagraph with Computer interface
Repairs
About Us

Sporicidin Disinfectant Products

Mold Remidiation
Air Duct Cleaning
Sewer Cleanup

Request
Information
We Accept Mastercard!We Accept Visa!We Accept American Express!
Electronic Development Labs, Inc.
 
Analagraph®
Analagraph® RecorderThe Analagraph® Recorder, when used in conjunction with the Nervo-Scope® ETS-7 or ETS-8, provides a permanent record to log and chart the amount of existing heat differences indicated from your Nervo-Scope® readings.

The Analagraph® Recorder is a valuable and efficient tool in documenting patient assessments and providing a pattern reference for pre and post check of patients. This information indicates any change of reading, thus establishing a pattern which may assist in determining the frequency of adjustments.

Easy to use and operate, the Analagraph® Recorder has been trusted for over 50 years in the Chiropractic community.

CHR1: $1,995.00

 

Power Input: 120Vac @ 60Hz, 1A
Overload Protection: 3 AG, 250V slo-blow glass body fuse (rear panel)
Ambient Operating Range: 32° to 140°F
Relative Humidity (max.): 10% to 90% non-condensing
Recorder Resolution: 0.02°F
Power Consumption: Recorder- 5 watts @ 0.3 amps on recording mode. 1/2 watt on standby
Printing Method: Direct thermal
Print Resolution: 200 x 800 DPI
Graph Speed Rate: Low: 6 inches per minute (2.5 mm sec.)
High: 9 inches per minute (3.75 mm sec.)
Graph Paper Type: Thermal activation
Graph Paper Size: 2 inch wide roll x 100 feet long
Graph Paper Thickness: 0.0025"
Graph Grid Size: 0.195" squares x 8 horizontally x continuous vertically
Switching:Power: On/Off rocker switch on rear panel
Graph On/Off: Starts/stops thermal graphing
Time Marker: Automatic horizontal dashed lines every 3 vertical grid squares
Manual Marker: Allows manual placement of horizontal dashed lines at any vertical interval
High/Low Speed: Sets graph paper speed rate
Audible Sound: Beep occurs for "graph on", "time marker" & "manual marker" intervals
Green Light indicator: For "graph on" (active)
Red Light Indicator: For "graph off" (standby)
ETS-7/ETS-8 Input Socket: Accepts coil cord, linking Nervo-Scope to Analagraph
Coil Cord: 6 ft. (expandable to 12 ft.) 6 wire pickup
Case: High impact Black ABS with handle. Powder coated front/rear panels
Size: 8.5" width x 6.4" height x 9.2" deep. Not including handle
Weight: 5 lbs.
Replacement Recording Paper Rolls - #CHR-AGP-CASE
Case / 100 Rolls $350.00
Single Rolls $3.50/each (10 Roll Minimum Order)
   
{Cell 4}
Electronic Development Labs, Inc.
EDL Tool & Die
244 Oakland Drive
Danville, VA 24540
USA
Toll-Free: 1-800-DIAL-EDL
(1-800-342-5335)
Phone: 434-799-0807
Fax: 434-799-0847
chirosales@edl-inc.com